Automation

CONNECTING A SINGLE PHASE FOR A THREE PHASE MOTOR
The 230 / 400V engine is factory-wired in a star configuration:

To connect a single phase inverter to the 230 / 400V motor, unscrew the nuts and remove washers together with the plates:

The plates should be mounted in parallel, and the shielded cable from the inverter should be connected as shown in the picture below:

WHEN THE MOMENT IS FULLY CONTROLLED BY THE INVERTER
Please note that above rated values ​​(above 50 Hz) the motor torque will drop. In the frequency range from 0 to 50 Hz, the power increases and reaches its maximum value at 50 Hz.

VECTOR OPERATING MODE INVERTER
Inverters that have the option of factory vector control are set to scalar control. To set the vector control, set the H40 parameter to 3 by performing Auto-Tuning (H41 = 1).

CONTACT

Branch in Warsaw tel: (22) 632-24-45
Branch in Łomianki, tel: (22) 751-99-39
kacperek@kacperek.pl

The sales department works at 7.00-15.30.

It is possible to pick up orders from the branch in Łomianki outside the working hours of the sales department after prior agreement with the merchant conducting the order. No prior agreement may result in the goods not being ready for collection.

Irregularity Report Form

© 2018 Kacperek | All rights reserved. | Execution: GoldKey
Top